Welcome to Spring, replete with eighty degree weather one day and snow the next. At least this gives FUNTRAK members a reason to try and keep warm and build new modules. That’s exactly what members John Fleming, Jim Domser, Lorenzo Franchi, and Brian King did on Sunday, May 19th. After a highly successful meeting on May 7th, which included new members Bill Whittaker and Bill McComb, plans were finalized to construct the new reverse end loop for the N scale one trak t-trak layouts. Future plans for building more HO scale t-trak modules were decided and construction on those will begin in the near future. A general consensus found that most people favored the double length modules for HO since the single modules were more difficult to scenic. Sometimes, more is better. Construction of the N scale loop modules went well and track was laid on the three corner modules. The specialty module could not have track laid yet because all the sensors and electrical devices were not finalized at this time. This project has entailed getting help and advice from Canada, Australia, Syracuse, and Rochester. There is a lot more to automating a conventional reverse loop than at first meets the eye.

FUNTRAK will be using an Arduino micro controller to control all the necessary electrical and electronic actions involved in this endeavor. Brian has been tasked with coordinating all the programming and installation of the required devices to make this project work. Without the assistance of Mark Bean in Australia, the programming would not have progressed as far as it has. David King from Canada lent his expertise in overcoming some of the electrical anomalies while Jeff Faust in Rochester has contribute his knowledge to help out with the project. Of course, our friend Rich Pettito in Syracuse contributed to the beginning of all this when he donated a beautifully scenicked diorama that has the single track of one trak on it. This is what got most of this started. Thanks Rich!

As the pictures show, the construction went very well. The modules were cut, assembled, and the track laid down in relatively short order. Some minor adjustments and everything was ready to be tested. The small locomotives designed to be operated on the tight radius loop were tested and a few cars were run around the loop to make sure the track work was satisfactory. All seemed to work properly for the tests. Now we will see how everything goes when all the other equipment is installed. The critical part will be getting the software to do the right things in the right order. Time will tell. It seems FUNTRAK is not the only club with that ever had lenient “rules”. Club member John Quinn provided some insight into the “rules” of one of the former clubs he was a member of a few years back.

“Ties and Rail” Railroad Club Rules were as follows:

1) Anyone who loves trains, and agrees to these rules, is immediately created a vice-president.

2) Meetings are held whenever two members are sober enough to recognize each other.

3) Any member who tries to create any more rules or hold a business meeting is automatically expelled.

Seems reasonable to me. A little tongue in cheek is always nice to keep things on the light-hearted side. Thanks for sharing these rules with us, John. Maybe FUNTRAK can incorporate some of them into our constitution.

Upcoming events include a small HO setup at Dave’s Diner on June 25th. This is always a fun show for FUNTRAK since it is held outdoors and there are lots of other activities going on at the same time. The old cars, the DJ and music, the food, as well as the trains and camaraderie all contribute to a great evening of fun. Come on down and enjoy all the fun with us. See you there!

Brian